CorrVerter® is a fast drying, water-based one-coat system (primer) that converts rusted surfaces to a hydrophobic passive layer and prevents 
further rusting thru the unique formulation of chelating agents and PVDC resins. 
UFI: FM30-30MW-500H-F6AX

PACKAGING & STORAGE
CorrVerter® is available in 1 gallon (3.8 L) and 5 gallon (19 L) pails. Keep product from freezing.
To ensure best product performance, store in original packaging, indoors, and out of direct sunlight at 40-100 oF (4-38 oC).

APPLICATION
Surface Preparation
Substrate should be free of loose rust, grease, oil, dirt, fingerprints, drawing compounds, rust inhibitors (except Cortec®approved), or any other surface contamination that could affect adhesion. Consult Cortec® Technical Service and/or test system adhesion prior to full scale application. It is recommended to remove any loose rust prior to application. 
When solvent based topcoats are applied over CorrVerter®, compatibility must be checked. All Cortec® High Performance Coatings can be topcoated over CorrVerter®.
Note: Make sure dew point is more than 5 °F (2 °C) less than air temperature for application. Power agitate to a uniform consistency using a “squirrel cage” type mixer, hand-held drill mixer, or other equivalent method. Can be diluted up to 15% with water. CorrVerter® can be applied by spray, roll, brush, or dip.